Front Hybrid Control Arms Superior Engineering Hyperflex Lift 4"

• Made of high-grade BIS80/Strenx700 steel
• High-strength bushings
• 32mm thickness for increased durability
• Pre-installed rubber bushings
• Laser-cut according to precise measurements
• Superior Engineering logo on the side
• Compatible with factory stabilizer and ABS lines
• Designed to perfectly fit a 4" lift
• Sandblasted for better rust protection
• Powder coated for increased durability
• High-grade BIS80/Strenx700 steel does not crack unlike the cast iron used in factory control arms
• Designed to achieve proper suspension geometry for precise handling on both asphalt and off-road
• Bushings of different sizes than factory ones will not fit
• Possibility to use factory bushings

Notes:

• Control arms are dedicated to front stabilizer mounting brackets with a screw spacing of 85mm
• Verify if ABS sensor wires can move freely throughout the full range of motion
• Factory bump stops may require extension